Procom FBNSD400T-ZC Series Owner's Operation And Installation Manual page 11

FOR NATURAL GAS
INSTALLATION: YELLOW
1. Remove the metal cap installed over the
NG regulator inlet.
2. Install metal cap over propane regulator
inlet. This will keep debris out of regulator.
Metal Cap
Yellow Natural Gas Plunger
Install Gas Fitting Here
200348-01C
INSTALLATION
Brass
Fitting
Metal Cap
DO NOT REMOVE
www.usaprocom.com
Use only the cap supplied on the
regulator. Do not use an off the
shelf pipe plug. This can damage
the plunger. The supplied regula-
tor cap is designed so it will not
engage the unused gas type.
3. Apply thread sealant to the threads on
the connection fitting. While pushing in,
rotate the fitting clockwise until the threads
engage the regulator. After the fitting has
been hand tightened into the regulator
use a wrench to complete tightening of the
fitting. Install additional fitting to connect
to the house supply.
Use only the metal cap. DO NOT
use an off the shelf 3/8" NPT pipe
cap. This will damage the plung-
ers located inside the regulator.
DO NOT TRY TO REMOVE THE
PLUNGERS FROM INSIDE THE
REGULATOR. THE PLUNGER
WILL BE PUSHED BACK AS THE
FITTING IS INSTALLED. REMOV-
ING THE PLUNGERS WILL VOID
THE WARRANTY.
Make sure the type of gas being
used is correct. Check to make
sure the connection fitting is in
the correct inlet on the regula-
tor. Refer to Connecting to Gas
Supply, page 14.
If you are using natural gas
and the pilot will not light, see
Troubleshooting, page 24.
11