Table of Contents
Advertisement
RRU3832&RRU3632
Installation Guide
----End
9.8 Installing an RRU Alarm Cable
This section describes the procedure for installing an RRU alarm cable.
Procedure
Step 1 Use an M3 Phillips screwdriver to loosen the screws on the dustproof cap on the EXT_ALM
port and remove the dustproof cap.
Step 2 Connect the waterproof DB15 connector at one end of the RRU alarm cable to the EXT_ALM
port on the RRU, as shown in
Issue 05 (2014-06-30)
Figure 9-18 Installing an RRU AISG extension cable
5.
Route the cables according to the instructions in
use cable ties to bind the cables.
6.
Label the installed cables according to the instructions in Attaching an L-Shaped
Label.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure
9-19.
9 Installing RRU Cables
9.1 Cabling
Requirements, and then
103
Advertisement
Table of Contents
