Related Manuals for Huawei RTN510
Summary of Contents for Huawei RTN510
- Page 1 Security Level: Safe City RTN510/PowerCube 500 DCN Configuration Guide www.huawei.com Version: V1.0 (20190130) HUAWEI TECHNOLOGIES CO., LTD.
- Page 2 RTN510: all versions network. Direct access to the third-party network RTN510: all versions The RTN510 AP/RT is used as the aggregation node to connect to the third-party network. by the AP/RT on the aggregation node HUAWEI TECHNOLOGIES CO., LTD. Huawei Confidential...
- Page 3 NE. RT Site Configuration Principles Enable the DHCP client function on the RTN510 RT, PowerCube 500-1, and PowerCube 500-2. The AP on the aggregation node assigns IP addresses to them. Note: After the DHCP client is enabled, the IP address allocated by the DHCP server is used to access the NE.
- Page 4 3. Disable the DHCP client function. 1. Configure the NE IP address and gateway IP address. Configuration Example of the RTN510 AP on the Aggregation Node Enable the DHCP server function, and configure the IP address 2. Configure the DCN protocol type.
- Page 5 Configuration Example Configuration Example of the RT Site 1. Enable the DHCP client function on the RTN510 RT. 2. Enable the DHCP client function on the PowerCube 500. HUAWEI TECHNOLOGIES CO., LTD. Huawei Confidential Page 5...
- Page 6 NE. RT Site Configuration Principles Enable the DHCP client function on the RTN510 RT, PowerCube 500-1, and PowerCube 500-2. The AP at the aggregation site assigns IP addresses to them. Note: After the DHCP client is enabled, the IP address allocated by the DHCP server is used to access the NE.
- Page 7 Configuration Principles of the RTN510 RT and Downstream PowerCube 500 Enable the DHCP client function on the RTN510 RT, PowerCube 500-1, and PowerCube 500-2. The AP at the aggregation site assigns IP addresses to them. Note: After the DHCP client is enabled, the IP address allocated by the DHCP server is used to access the NE.
- Page 8 Configuration Example of the PowerCube 500 on the Aggregation Node 3. Configure the NE NMSif IP address. 1. Configure the NE IP address and gateway IP address. 2. Configure the DCN protocol type. 4. Disable the DHCP client function. HUAWEI TECHNOLOGIES CO., LTD. Huawei Confidential Page 8...
- Page 9 Configuration Example Configuration Example of the RTN510 AP on the Aggregation Node Configuration Example of the RT Site Enable the DHCP server function, and configure the IP address pool and DHCP 1. Enable the DHCP client function on the RTN510 RT.
- Page 10 NMS to access the device must be tagged with a management VLAN ID. The 2. Disable STP for the port used by the third-party switch to connect to the RTN510. default management VLAN ID for the PowerCube 500 and RTN 510 is 4094.
- Page 11 Configuration Example Configuration Example of the RTN510 AP on the Aggregation Node Configuration Example of the RT Site 1. Enable the DHCP server function, and configure the IP address pool and DHCP gateway IP address as 1. Enable the DHCP client function on the RTN510 RT.
- Page 12 There are a number of factors that could cause actual results and developments to differ materially from those expressed or implied in the predictive statements. Therefore, such information is provided for reference purpose only and constitutes neither an offer nor an acceptance. Huawei may change the information at any time without notice.