Installing The Rru On U-Steel - Huawei RRU3832 Installation Manual

RRU3832&RRU3632
Installation Guide
Step 6 Install the fourth RRU onto the fourth main bracket, use an inner hexagon torque screwdriver
to tighten the captive screw into the holes of the attachment plate and main bracket to 5 N·m
(44.25 lbf·in.) so that the attachment plate and main bracket are firmly secured, as shown in
Figure
Figure 8-19 Installing the fourth RRU onto the fourth main bracket
----End

8.3 Installing the RRU on U-steel

This section describes the procedure and precautions for installing the RRU on U-steel. An RRU
can be installed on U-steel secured on the ground or a tower. Each piece of U-steel allows only
one RRU to be installed in standard or reverse mode.
Prerequisites
Before you install an RRU on U-steel secured on a tower, the RRU and its mounting brackets
are hoisted onto the tower. For details, see
The hoist clamp on the main bracket is secured properly.
Issue 05 (2014-06-30)
8-19.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7.1 Hoisting an RRU onto a
8 Installing the RRU
Tower.
63