Canon 2213C002 Instruction Manual page 143

IP Streaming
After connecting the camcorder to a network, you can stream the camcorder's live video and audio* over IP to a
compatible IP video decoder** connected to the network. You can use IP streaming for live broadcasts or to
send a news flash report from a location with poor network connectivity.
While IP streaming is activated, internal recording on a card as well as the external recording-only mode
([ø External Rec Only (SDI)] (m only) or [ù External Rec Only (HDMI)], A 119) are both disabled.
* Only 2 channels. During 4-channel audio recording, you can select which two channels to stream over IP.
**This can be a dedicated video transfer device or decoder software on a computer. For details about compatible decoders,
please visit your local Canon Web site.
Configuration of video streamed over IP
Video format
(compression)
XF-AVC, MP4
(MPEG-4 AVC/H.264 compression)
Operating modes:
IP Streaming Settings
Before you can stream video over IP, you need to configure settings related to the transfer like the protocol and
port number to use. You can also select the configuration of the streamed video.
Camcorder Settings
1 Configure an Ethernet network connection (A 133).
2 Select [IP Streaming Settings].
> [B ! System Setup] > [Network Settings] > [IP Streaming Settings]
3 To select the video streaming configuration, touch the [i] button next to [Streaming Output
Signal].
• Select the desired option and then touch [L].
4 To select the audio streaming channels, touch the [i] button next to [Audio Output Channels].
• Select the desired option and then touch [L].
5 Touch the [i] button next to [Protocol].
• Select the desired option and then touch [X].
• If you selected [RTP+FEC], complete the error correction settings (A 144).
Options
[UDP]: This protocol prioritizes transfer speeds but does not guarantee the reliability/integrity of the data. Lost or
delayed IP packets are ignored.
[RTP]: Standard protocol for video/audio broadcasts over the Internet. Lost or delayed IP packets are ignored.
[RTP+FEC]: This setting uses the RTP protocol and adds a layer of FEC error correction so the receiving side* can
recover lost or delayed IP packets.
* A decoder compatible with FEC error correction is required.
Receiver Settings
1 Select [IP Streaming Settings].
> [B ! System Setup] > [Network Settings] > [IP Streaming Settings]
Video
Bit rate Resolution
9 Mbps, 4 Mbps 1920x1080
Streaming configuration
Frame rate
59.94i
IP Streaming
143
Audio
MPEG-2 AAC,
256 Kbps, 2 channels