Canon 2213C002 Instruction Manual page 121

Using the HDMI OUT Terminal
The HDMI OUT terminal also offers a digital connection and outputs both the video and audio signals. You can
output also the time code signal and onscreen displays (A 153). The audio output signal will be 2-channel
linear PCM audio (16-bit, 48 kHz sampling). When recording with 4-channel audio, you can select the audio
channels that are output (A 122).
1 Select the HDMI OUT terminal.
> [£ ! Display Setup] > [Output Terminal] > [ù HDMI]
2 Select [HDMI Max Resolution].
> [£ ! Display Setup] > [HDMI Max Resolution]
3 Touch the desired maximum resolution and then touch [L].
• For details, refer to the Video Output Configuration table (A 117).
4 mode only: If necessary, output also the time code signal.
> [3 # Recording Setup] > [HDMI Time Code] > [i On] > [X]
NOTES
• The HDMI OUT terminal is for output only. Do not connect the camcorder to another device's output terminal
using the HDMI OUT terminal as this will cause a malfunction.
• Correct operation cannot be guaranteed when connecting the camcorder to DVI monitors.
• Video may not be output correctly depending on the monitor. m In such case, try using the SDI OUT
terminal.
• You can set both [3 Recording Setup] > [Rec Command] and [HDMI Time Code] to [i On] to use the
camcorder's REC button to control also the recording operation of an external recorder connected to the
HDMI OUT terminal. The camcorder's time code signal will be output as well.
• The time code signal will not be output from the HDMI OUT terminal in the following cases.
- In mode.
- During SD (720x480) output.
- When slow & fast motion recording is activated.
• When the resolution is set to 3840x2160 and the frame rate is set to 59.94P (A 48), to view the camcorder's
output signal on a TV or external monitor connected using an optional High Speed HDMI cable, the TV or
external monitor must be compatible with 4K/60p video.
Connecting to an External Monitor or Recorder
121