Lutron Electronics AuroRa AR-ENT-2S3D Series Package Installation Manual page 13

4
Uninstall switch
Figure 4A
1 2
3
4 (ground wire)
5
Install dimmer or switch
Dimmer
neutral wire
brass screws
ground wire
black
screw
green wire
6
Mount dimmer or switch
Need help? Contact Lutron Technical Support 24/7: 800.523.9466
Figure 4B
1
4 (ground wire)
Neutral
Refer to page 8 step 4B for
instructions. (pull out wires 1, 2, 3)
Switch
brass screws
black
screw
silver screw
7
Replace wallplate
OR
Traditional
✓ Helpful Hint: See page
6—installing the designer insert
if using designer wallplate.
A. Tag the wire attached to
B. Disconnect the wires from
2
3
Wire
A. Connect the green or bare wire
Connector
B. Connect the tagged wire to
neutral wire
C. Connect one of the remaining
D. Connect the remaining wire to the
ground wire
E. For AuroRa switch connect the
green wire
white wire
(provided
by Lutron)
Designer
the different colored screw.
This screw is usually labeled
COMMON.
the switch.
NOTE:
If intending to install an AuroRa
switch in this location, ensure
neutral is available before
disconnecting/uninstalling switch.
(ground wire) to the green wire on the
dimmer/switch with a wire connector.
the black colored screw on
the dimmer/switch.
wires to either of the gold colored
screws (brass) on the dimmer/switch.
remaining gold colored screw (brass)
on the dimmer/switch.
neutral (usually white) wire to the
silver colored screw on the switch
using white wire provided by Lutron.
(see page 22 for additional info)
8
Turn power on at circuit
breaker or replace fuse
WARNING
To avoid fire, shock or death,
if breaker trips do not reset
breaker to "on" again until
fault has been corrected.
Lutron
®
|
13