Setting The Timer - ProMinent Sigma2 S2Cb Operating Instructions Manual

'Menu'
Set up /

'Setting the timer'

9.4.2
9.4.2.1 Administration functions for commands
'Init' Initial conditions
9.4.2.2
'Time event' and Time
9.4.2.3 Selecting the
58
'Menu / Information è Timer è Set timer è ...'
You can create commands (program lines) for a timer program in the
timer' menu.
You can create up to 32 commands (program lines).
You can then use the administration functions to manage the commands -
Ä Chapter 9.4.2 ' 'Setting the timer' ' on page 58 .
Use the 'Clear all' function to clear all commands (the program).
Create the command as follows:
1 - Create a command (program line)
2 - Select the triggering event and time
3 - Select the action and value
4 - Check the command
5 - Save command by pressing the Clickwheel
6 - Create the next command if necessary
The following administration functions are available to manage the com‐
mands (program lines):
'Display' (only if commands entered)
n
'Change' (only if commands entered)
n
'Clear' (only if commands entered)
n
'New'
n
'New' to create a new command.
Use
'Init' to specify initial conditions at the start of the program - see
Use
Ä Chapter 9.4.2.4 'Select the action and value' on page 59 .
You can select a time event (cycle) and a time as well:
Time event
'Hourly'
'Daily (Mon-Sun)'
'Weekdays1 (Mo-Fr)'
'Weekdays1 (Mo-Sa)'
'Weekend (Sa+Su)'
Time
hourly at the x minute
daily at the time mm.ss, Monday to
Sunday
daily at the time mm.ss, Monday to
Friday
daily at the time mm.ss, Monday to
Saturday
daily at the time mm.ss, Saturday
and Sunday
'Set