Setting Up The Pump; General; Setting The Slave Address; Switching Profibus ® To Active/Inactive - ProMinent DULCO flex Control Installation And Configuration Manual

Setting up the pump

2 Setting up the pump

2.1 General

2.2 Setting the slave address

2.3 Switching PROFIBUS
4
Familiarise yourself with the process: We describe here how to set up the
pump for PROFIBUS
PROFINET protocol via the DULCOnvert in the master control system.
®
For this reason, "PROFIBUS
many points.
You can set up a pump with PROFIBUS
standard pump, with the addition of bus functionality.
The pump interrupts the set-up process in the event of a pause longer
than 60 seconds.
The address is pre-set to "125". There is no need to manually set the slave
address if a master in the PROFIBUS
addresses.
1. Press the [Menu] key.
[Clickwheel] to 'Fieldbus' and press the [Clickwheel] .
2. Turn the
[Clickwheel] to 'BUS address' and press the [Clickwheel] .
3. Turn the
INFORMATION!: Always set the 3-digit PROFIBUS
1.
Set the 1st digit with the
ð The 2nd digit of the address is highlighted.
2. Set the 2nd digit with the
key.
ð The 3rd digit of the address is highlighted.
3. Set the 3rd digit with the
ð The address has now been fully entered.
® to active/inactive
'Fieldbus' to 'active' in the operating menu for the pump to be
Set the
controlled by the PROFIBUS
1. [Menu] key.
Press the
[Clickwheel] to 'Bus active' and press the [Clickwheel] .
2. Turn the
[Clickwheel] to 'Active' or 'Inactive' and press the
3. Turn the
[Clickwheel] . You're done!
All external inputs of the pump, such as level monitoring, dosing monitor
and external control (pause, contact input, analogue input), will continue to
function while the PROFIBUS
expected reactions as is the case with a pump without PROFIBUS
module. The pump transmits relevant information via the PROFIBUS
the master (PLC, PC etc.).
If the PROFIBUS ® is set to
previously selected will be reloaded.
If the pump is switched to another operating mode, then the pump will stop
and can only be restarted using the
® mode. You will later meet the pump's
® " is interchangeable with "PROFINET
module in the same way as the
®
® segment assigns the slave
[Clickwheel] and press the
[Clickwheel] and press the
[Clickwheel] and press the [Clickwheel] .
® .
is 'active' . The external inputs lead to the
®
'inactive' , the settings for the operating mode
[Stop/Start] key.
® " at
® address to "002".
[Priming] key.
[Priming]
®
® to