System Board Filler Replacement - Lenovo ThinkSystem SR950 Setup Manual

• If you are not installing another system board, install the compute tray and front cover. See "Install a
compute tray" on page 307 and "Install the front cover" on page 322.
• Update the machine type and serial number with new vital product data (VPD). Use the Lenovo XClarity
Provisioning Manager to update the machine type and serial number. See "Update the machine type and
serial number" on page 337.
• Enable TPM/TCM. See "Enable TPM/TCM" on page 338
• Optionally, enable Secure Boot. See "Enable UEFI Secure Boot" on page 341.

System board filler replacement

System board fillers are in the upper or lower compute tray that is accessed from the front of the server.
Remove a system board filler
Remove a system board filler by pressing the release clips on the filler, and sliding it out of the compute tray.
S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
"
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
Before you remove the system board filler:
1. Remove the front cover. See "Remove the front cover" on page 322.
2. Remove compute tray where the system board filler is installed. See "Remove a compute tray" on page
305.
Complete the following steps to remove the compute system board filler:
Watch the procedure. A video of the replacement process is available:
•
YouTube
•
Youku
ThinkSystem SR950 Setup Guide
312
" on page 56 " " on page 254