Lenovo ThinkSystem SR950 Setup Manual page 356

Figure 106. Memory baffle installation
Attention: To prevent damage to memory modules and memory module sockets, you must open the
retaining clips at both ends of each memory module.
Note: Each memory air baffle spans six memory modules.
Step 1. Make sure that all six pairs of memory module connector retaining clips spanning the memory air
baffle are open.
Step 2. Hold the memory air baffle so the "REQUIRED FOR COOLING" text on the baffle is right-side up
and facing away from the memory modules; then, slide the lower half of the slots in the air baffle
over the memory module connector retaining clips.
Step 3. Slide the air baffle up and over the memory module retaining clips until the air baffle is positioned
on the surface of the compute system board.
Step 4. Make sure that each memory module aligns with its connector; then, seat each memory module.
See "Install a memory module" on page 355 for more information.
Note: Make sure that all memory module connector retaining clips spanning the memory air baffle
are closed, even if a memory module is not installed in the connector.
Step 5. After installing each memory baffle, make sure that it is secure by attempting to lift and remove it.
Installation of the air baffle was performed correctly if the air baffle remains in place.
Step 6. If you are installing additional memory air baffles, do so now.
After you install a memory air baffle:
1. Install the upper system board or system board filler, if it was removed. See "Install a system board" on
page 310.
2. Install the compute tray where the system board is installed. See "Install a compute tray" on page 307.
3. Install the front cover. See "Install the front cover" on page 322
ThinkSystem SR950 Setup Guide
352