Table of Contents
Advertisement
P-sensor cable
Follow the instructions to replace the P-sensor cable.
For access, remove these FRUs in order:
• "ThinkPad Pen Pro (for ThinkPad L13 2-in-1 Gen 5 only)" on page 62
• "Base cover assembly" on page 63
• "Built-in battery" on page 65
• "Speaker assembly" on page 74
Step 1.
Remove the P-sensor cable as shown below.
Step 2.
Install the P-sensor cable in reverse order.
When installing: Ensure that the connectors are attached firmly.
System board
Follow the instructions to replace the system board.
Notes:
• After replacing the system board, use the Maintenance Utility to bind the model type, serial number, and
Brand ID of the computer with the new system board. Refer to
HT506954
for instructions on how to do that. As an alternative, you also can use the Golden Key U1 tool
for that purpose. Refer to
Important notices for handling the system board:
When handling the system board, read the following:
• Some components mounted on a system board are very sensitive. Improper handling of a system board
can cause damage to those components, and may cause a system malfunction.
• The system board has an accelerometer, which can be broken when several thousands of G-forces are
applied.
82
ThinkPad L13 Gen 5,ThinkPad L13 2-in-1 Gen 5 and ThinkPad S2 Gen 9 Hardware Maintenance Manual
https://support.lenovo.com/us/en/solutions/ht507251
https://support.lenovo.com/us/en/solutions/
for instructions.
Advertisement
Table of Contents
