Lenovo ThinkSystem SR950 Setup Manual page 219

Figure 29. Processor locations on system board
Figure 30. Processor layout for multi-processor systems (viewed from front of server)
Complete the following steps to install a PHM.
Watch the procedure. A video of the installation process is available:
•
YouTube
•
Youku
Step 1. Remove the processor socket cover, if one is installed on the processor socket, by placing your
fingers in the half-circles at each end of the cover and lifting it from the system board.
Step 2. Install the processor-heat-sink module on the system board.
.
Chapter 3 Server hardware setup
215