Lenovo ThinkSystem SR950 Setup Manual page 365

Figure 111. Riser for slot 10 to 15 (riser 2) removal
Step 1. Loosen the two captive screws (items 1 in preceding figure) that secure the riser to the I/O tray
board.
Step 2. Lift the riser up and out of the I/O tray.
After you remove the riser:
• If you are removing the riser and are not installing a replacement:
1. Install the screw that secures the I/O tray board to the I/O tray (item 3 in the figure). This screw
replaces the captive screw on the rear edge of the riser below the midplane connectors. Screw
location is labelled "Remove screw before installing riser" on the I/O board.
2. Install the I/O tray fillers in adapter slot 10 to 15 (item 4 in the figure).
If you are instructed to return the riser, follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.
Remove the riser bracket for slot 14 to 15 (riser 2)
The riser bracket for slot 14 to 15 is attached to the slot 10 to 15 I/O tray riser that is accessed from the rear
of the server. After removing the I/O tray and the riser for slot 10 to 15 (riser 2), release the retaining clips and
remove the bracket from the riser.
S002
CAUTION:
Appendix B. Component reference
361