Front Operator Panel - Lenovo ThinkSystem SR950 Setup Manual

11 VGA Video port
Connect a monitor to this connector.
Notes:
• When the optional front VGA connector is in use, the rear one will be disabled.
• The maximum video resolution is 1920 x 1200 at 60 Hz.
Drive LEDs
Figure 6 "Drive LEDs" on page 27 illustrates the LEDs on each drive.
Figure 6. Drive LEDs
Table 27. Drive LEDs
Callout
Drive activity LED (green)
1
1 Drive activity LED (green):
Each hot-swap drive comes with an activity LED. If the LED is lit, it indicates that the drive is powered, but
not actively reading or writing data. If the LED is flashing, the drive is being accessed.
2 Drive status LED (yellow):
These LEDs are on SAS or SATA hard disk drives and solid-state drives. When one of these LEDs is lit, it
indicates that the drive has failed. When this LED is flashing slowly (one flash per second), it indicates that
the drive is being rebuilt. When the LED is flashing rapidly (three flashes per second), it indicates that the
controller is identifying the drive.

Front operator panel

The following illustration shows the controls and LEDs on the front operator panel.
Table 28. Operator panel front controls and indicators
Callout
Power button and power LED
1
Network activity LED
2
Callout
Drive status LED (yellow)
2
Callout
System ID button/LED
3
System-error LED
4
Chapter 2
.
Server components
27