Lenovo ThinkSystem SR950 Setup Manual page 244

"
CAUTION:
Make sure that all server power cords are disconnected from their power sources before performing
this procedure.
If you are installing an optional LOM adapter in slot 9, install it before installing the riser for slot 10 to 15 (riser
2). See "Install a LOM adapter in slot 9" on page 228.
Before you install the riser for slot 10 through 15 option:
1. If the I/O tray is installed in the server, remove it. See "Remove the I/O tray" on page 334.
2. Make sure that there is no screw (item 2 in following figure) securing the I/O tray board to the I/O tray in a
location where a captive riser screw will be installed.
3. Make sure that there are no I/O tray fillers installed in riser slot 10 to 15.
4. If you are Installing the optional slot 14 to 15 bracket, make sure that it is in place. See "Install a riser
bracket for slot 14 to 15" on page 241.
5. Install adapters in the riser. See "Install a PCIe adapter in slot 10 to 15" on page 232.
6. If any of the adapters in the riser have internal cables, make sure that they are connected before
installing the riser in the I/O tray.
Complete the following steps to install the riser for slot 10 to 15.
Watch the procedure. A video of the installation process is available:
• YouTube
•
Youku
ThinkSystem SR950 Setup Guide
240
" on page 56 " " on page 254