Wheelchair Occupant Restraint; Wheelchair Lift Removal For Storing Or Maintenance Purposes - PREVOST X3-45 COACH 2018 Operator's Manual

Wheelchair Occupant Restraint

Secure the wheelchair occupant in the following
manner:
Fasten and adjust the lap belts so it sits snug
across the hips. Make sure that you place the
lap belt buckle on the center aisle side. Fasten
the shoulder belt by inserting the lap belt tab into
the shoulder belt buckle. A retractor adjusts
shoulder belt length automatically.
WARNING
A snug fit with the lap belt positioned low on
the hips is necessary to maximize safety. The
belt should not be worn or twisted.
pinching the belt and/or hardware.
wear over rigid or breakable objects such as
eyeglasses, pens or keys as these may cause
injuries.
CAUTION
The safety belt buckle provided with the red
release button must always be located on the
center aisle side.
To unfasten the belts, press the red release
button on the shoulder belt buckle first and then
unfasten the lap belt by pressing the red release
button on the lap belt buckle.
WHEELCHAIR LIFT REMOVAL FOR STORING
OR MAINTENANCE PURPOSES
Disconnect WCL system connector located at
compartment ceiling.
Remove 4 fixing
compartment, on each side of platform.
Grasp the platform and pull firmly, sustaining a
constant pull so that the platform slides onto the
rails until the carriage come in contact with the
stops.
Pull the platform until the rear carriage hit
against the stops.
Remove platform completely.
WARNING
For better stability, keep the platform at
minimum height when moving.
Avoid
Do not
bolts located inside
PA1627 X3-45 Operator's Manual
Other Features
WARNING
Before moving platform, make sure that floor is
level and free of obstacles.
WHEELCHAIR LIFT REMOVAL FOR STORING
OR MAINTENANCE PURPOSES
Secure the first two telescopic legs onto the
platform.
NOTE
There are two telescopic legs for each
platform side. The proper side is indicated
onto the telescopic leg.
Turn telescopic leg crank to raise the carriage to
be able to clear the stops.
INSTALLATION OF TELESCOPIC LEGS
Pull the platform until the rear carriage hit
against the stops.
Secure the two rear telescopic legs onto the
platform then turn telescopic leg crank to be
able to clear the stops.
Remove platform completely.
Lower the platform to minimum height using the
telescopic leg cranks before moving it.
WARNING
For better stability, keep the platform at
minimum height when moving.
WARNING
5-41
23333