PREVOST X3-45 COACH 2018 Operator's Manual page 142

Other Features
5-42
Never deploy the platform from enclosure while
standing on the telescopic legs.
WARNING
Telescopic legs were designed to support and
move the platform only, do not use as a work
table.
WARNING
Before moving platform, make sure that floor is
level and free of obstacles.
WHEELCHAIR LIFT INSTALLATION
Lower the front of the platform.
Push firmly and make sure that the platform
manual release shafts have turned to lock the
platform.
Secure the 4 fixing bolts located inside
compartment, on each side of platform. Apply a
torque of 60 lbf-ft.
Reconnect connector located at compartment
ceiling.
WHEELCHAIR LIFT INSTALLATION
Raise the platform to proper level.
Insert the platform so that the rear carriage
clears the stops.
Turn telescopic leg crank until the carriage
comes in contact with the rails.
Remove the two rear telescopic legs from the
platform.
Insert the platform until the front carriage clears
the stops.
Lower the front of the platform.
Remove the two front telescopic legs from the
platform.
Push firmly and make sure that the platform
manual release shafts have turned to lock the
platform.
Secure the 4 fixing bolts located inside
compartment, on each side of platform. Apply a
torque of 60 lbf-ft.
Reconnect connector located at compartment
ceiling.
When re-inserting platform into compartment,
make sure that carriage wheels are properly
aligned over the L. H. side triangular rail before
removing telescopic legs.
PA1627 X3-45 Operator's Manual
WARNING