Walk-Around Inspection (Before Every Trip) - PREVOST X3-45 COACH 2018 Operator's Manual

Table of Contents

Advertisement

WALK-AROUND INSPECTION (BEFORE EVERY TRIP)

NOTE
Inspect the coach in a circular manner as shown in the illustration.
Approaching the Coach
Check under the coach for oil, fuel,
coolant leaks or other signs of damage.
Check exterior body surfaces for signs
of breaks or damage.
Preparation
Drain
accumulated
accessory and wet air tanks.
Close air tank drain valves.
Start the engine and let the air pressure
build up to normal. Stop engine.
Switch on hazard warning flashers.
Make sure parking brakes are applied.
Step 1: Front Left Side of the Coach
Check condition of wheel rim. Especially
look for cracks, missing nuts, bent or
broken studs.
Check condition of tire: properly inflated,
no serious cuts, bulges, tread wear or
any signs of misalignment; valve stem
not touching wheel or rim; valve cap in
place.
Step 2: Front of the Coach
water
from
PA1627 X3-45 Operator's Manual
Care and Maintenance
Check
windshield
washer reservoir fluid level and add if
necessary.
Check for damage and clean if dirty.
Check windshield wiper arms for proper
spring tension.
Check wiper blades for any damage,
"dead" rubber and attachment to arm.
Check to see thst there is no mud,
snow, ice build-up or other obstruction in
front of the ACB radar sensor, if
applicable.
Check
clearance
lights, they should be clean, operating
and of the proper color. Refer to
"Exterior Lighting Verification" in Care
and Maintenance chapter.
Turn on headlights. High and low beams
should be operating and lenses clean. If
equipped, check fog lights. Refer to
"Exterior Lighting Verification" in Care
and Maintenance chapter.
Left and right front turn signal lights
clean, operating and proper color. Refer
8-19
and
headlights
and
identification

Advertisement

Table of Contents
loading

This manual is also suitable for:

X3-45 2017X3-45 2018

Table of Contents