Table of Contents
Advertisement
Appendix E – TPMS Troubleshooting Guide
NO PRESSURE
DATA
RECEIVED
Cycle the ignition between
the ON and OFF position
then check if TPMS telltale
indicator illuminates for 3
seconds.
YES
Check
that
all
antennas are properly
connected using the
"ANTENNA STATUS"
menu.
Reprogram a sensor
using
the
"LEARN
WHEEL ID" menu.
Remove
a
tire
to
check if the sensor
was installed inside
NO
PA1627 X3-45 Operator's Manual
Possible
causes:
TPMS
powered.
Wheels/tires
changed and sensors ID # has not been
reprogrammed into the display. Wheels
have been installed without sensors.
TPMS ECU does not communicate with
display due to a CAN-D-BUS network
problem. Antennas power is short-
circuited or defective.
Check TPMS ECU
fuse (F26 - 3A)
Disconnect
TPMS
ECU connector and
probe
to
confirm
proper 12V power
Check CAN-D-BUS
network between TPMS
and display
1
ECU
not
have
been
Advertisement
Table of Contents
Troubleshooting
