Ethernet Connection; Table 6. Ethernet Cable Pin-Outs - ADTRAN Total Access 362R Installation And Maintenance Manual

Total Access 362R Single Family Unit with RF Return Installation and Maintenance Guide

Ethernet Connection

When supporting up to two Gigabit operation (10/100/1000) use a CAT‐5 rated cable.
To connect Ethernet, complete the following steps:
1. Route the Subscriber Ethernet wires through the cable entry on the bottom of the enclo‐
2. Strip back the jacket of the subscriber Ethernet cable and connect the 4 pair twisted wires
Ethernet RJ-45 Pin-out
Pin
1
2
3
4
5
6
7
8
3. Insert the RJ‐45 connectors for each line.
Refer to Figure 23 on page 37 for a visual example of the final installation.
36
sure. A tie wrap point is provided for wire management (see Figure 22 on page 35).
to the RJ‐45 Plug using a RJ‐45 crimper. There are two RJ‐45 jack holders molded into the
enclosure (see Figure 22 on page 35). Refer to Table 6 for a list of Ethernet Cable Pin‐Outs.
Name
TRD0+
TRD0‐
TRD1+
TRD2+
TRD2‐
TRD1‐
TRD3+
TRD3‐

Table 6. Ethernet Cable Pin-Outs

Description
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Positive
Transmit/Receive Negative
Transmit/Receive Negative
Transmit/Receive Positive
Transmit/Receive Negative
Color Code
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
61187715G1-5B