Ethernet Connection; Table 9. Ethernet Rj-45 Pin-Out - ADTRAN GPON 452 Physical Installation Manual

5.3.8.2

Ethernet Connection

When supporting up to two Gigabit operation (10/100/1000Base-T) use a CAT-6 rated cable.
To connect Ethernet, perform the following steps:
1. Route the subscriber wires through the cable entry on the bottom of the enclosure.
2. Strip back the jacket of the subscriber Ethernet cable and connect the 4 pair twisted wires

Table 9. Ethernet RJ-45 Pin-Out

Pin
1
2
3
4
5
6
7
8
3. Insert the RJ-45 connector into the ETH 1 or ETH 2 Jack.
Refer to
61287802F1-34B
Revision B
to the RJ-45 Plug using a RJ-45 crimper. See
standard. There are two RJ-45 jack holders molded into the enclosure (see
page 40).
Name Description
TRD0+ Transmit/Receive Positive
TRD0- Transmit/Receive Negative
TRD1+ Transmit/Receive Positive
TRD2+ Transmit/Receive Positive
TRD2- Transmit/Receive Negative
TRD1- Transmit/Receive Negative
TRD3+ Transmit/Receive Positive
TRD3- Transmit/Receive Negative
Figure 18 on page 40 for an example of what the final installation should look like.
Table 9 for straight through cable wiring
Color Code
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Installation
Figure 18 on
41