Subscriber Connections; Pots Connections; Figure 22. Pots And Ethernet Connections - ADTRAN Total Access 362R Installation And Maintenance Manual

Subscriber Connections

Refer to Figure 22 and Figure 23 on page 37 to install subscriber POTS, RF and/or Ethernet
services.

POTS Connections

To connect POTS, complete the following steps:
1. Route the subscriber wires through the cable entry on the bottom of the enclosure. A tie
2. If using an RJ‐11 connector directly, it is recommended that the cable be terminated with
3. If using the Terminal Bridges, loosen each screw and attach the Green wire to the
61187715G1-5B
wrap point is provided for wire management (see Figure 22).
the RJ‐11 plugs after the subscriber wires have been pulled through the cable entry. Each
RJ‐11 connector is wired for a single line. There are two RJ‐11 jack holders molded into
the enclosure.
terminal, and the Red wire to the
TELEPHONE TROUBLESHOOTING
1. Identify the bad line.
2. Disconnect the plug from the appropriate POTS jack and plug
any working telephone into that jack.
If the telephone works, there is a problem inside the house.
If the telephone does not work, contact your service provider.
3. Remove the telephone and replace the plug into the POTS jack.
4. Close the unit.
TELCO ACCESS
12V , 1.5A

Figure 22. POTS and Ethernet Connections

RING
terminal and tighten.
RING
TIP
POWER
FXS 0/1
POTS 1
NETWORK STATUS
FXS 0/2
POTS 2
RING
TIP
POTS 1
POTS 2
ETH 0/1
ETH 0/2
ETH 1 ETH 2
TOTAL ACCESS 362R
1187715G1
TEL. NUMBER
CLEI
FXS 0/1
Two-screw
FXS 0/2
Terminal Bridges
Ethernet
Connections
RF Video
F-Type
Connector
Tie Wrap Point
Installation
TIP
35