Error Halt; Memory - AOpen DP5 User Manual

Error Halt

This parameter enables you to control the system stops in case of
error. The available settings are:
·
No Errors
·
All Errors
·
All, But Keyboard
·
All, But Diskette
·
All, But Disk/Key
The default setting is All Errors

Memory

The Memory parameters are for display only. These are determined
by the BIOS power-on self-test.
Base Memory
The POST detects the amount of base (or conventional) memory
installed in the system. The value of the base memory is 640 KB for
systems with 640 KB or more memory installed on the mainboard.
Extended Memory
The BIOS detects the amount of extended memory present during the
POST. This is the amount of memory located above 1 MB in the CPU
memory address map.
User's Guide
Award BIOS
.
3-5