Enabling the PS/2 Mouse (optional)
The system board accepts both AT and PS/2 mice. To enable the
PS/2 mouse, set the 2-pin jumper JP5 open. To disable, close pins 1-
2.
Clearing the CMOS
The jumper JP14 is a 2-pin jumper used to clear the values in the
CMOS.
You need to clear the CMOS if you forget your system
password. To do this, shut off the system power and short pins 1-2 of
JP14 for a few seconds. Then set the jumper to normal by leaving
JP14 open. Enter Setup to specify a new password.
Normal (default)
Clear CMOS
User's Guide
Hardware Setup
JP5
Enabled
Disabled
JP14
2-13