AOpen DP5 User Manual page 88

Onboard PCI IDE Chip
This parameter lets you enable or disable the onboard PCI IDE chip.
The default setting is Enabled
Onboard FDC Controller
If enabled, this parameter allows you to connect your floppy disk
drives to the onboard floppy disk connector instead of a separate
controller card. Change the setting to
a separate controller card. The default setting is
Onboard Serial Ports 1 and 2
These lines allow you to assign addresses for the board's serial
connectors. The serial ports can be assigned as follows:
Port
COM1
COM2
COM3
COM4
Disabled
User's Guide
Award BIOS
.
Disabled
Enabled
Address
3F8H (onboard serial port 1 default)
2F8H (onboard serial port 2 default)
338H
238H
Disables the onboard port
if you want to use
.
4-19