AOpen DP5 User Manual page 87

Award BIOS
The default setting for these parameters is Auto . This automatically
sets the system IRQ for the PCI slot.
Available IRQs
These parameters let you assign a system IRQ to each PCI slot. The
available settings are 3, 4, 5, 7, 9, 10, 11, 12, 14, 15 and NA. The NA
setting means no IRQ is assigned to the slot.
Auto
Setting the Slot 1/2/3/4 Using INT# parameter to automatically
sets the IRQ for each slot. You may also change the default to
another setting. If you do, make sure that the IRQs do not conflict.
PCI IRQ Activated By
This option lets the user set when to activate the PCI IRQ. The
available settings are Edge and Level. The Edge is the start of the
signal and Level is the point at which the signal is high. The default
Level
setting for this parameter is .
PCI IDE IRQ Map To
This feature enables you to control the PCI IDE IRQ mapping. The
available options are ISA, PCI-Slot 1, PCI-Slot 2, PCI-Slot 3, PCI-Slot
4 and PCI-Auto. The default is ISA.
Onboard PCI SCSI Chip
This parameter lets you enable or disable the onboard PCI SCSI chip.
The default setting is Enabled .
4-18 User's Guide