Cpu Fan Connector; Installation - AOpen DP5 User Manual

Hardware Setup

CPU Fan Connector

The DP5 system board has two two-pin CPU fan connectors marked
J5 and J6. To connect a CPU fan connector, simply plug it into the
fan connector onboard. Take note of the pin assignments of the
connector. See the following figure.

Installation

The full baby-AT size DP5 system board easily fits most housings. It
has mounting holes that conform to the standard system housing.
Some housings may differ slightly in design, requiring additional steps
to install the board. Read the documentation that comes with the
housing.
Make sure that you have already installed
the system board components like the
CPU and memory, and have set the
appropriate jumpers before you proceed
with the board installation.
2-22
+12V
GND
GND
2-pin fan power connector (J2)
User's Guide