Slots 1, 2, And 3 Using Int; Onboard Scsi; Available Irqs - AOpen DP5 User Manual

Award BIOS

Slots 1, 2, and 3 Using INT#

Each PCI slot supports four interrupt pins. These parameters let you
select which interrupt pin to use. The selections are interrupt pins A,
B, C, D and Auto. However, you must always start with interrupt pin
A. The INTA pin is automatically reserved for master function of the
PCI device. The remaining interrupt pins (INTB, INTC, and INTD) are
reserved for multifunction cards.
The default setting for these parameters is Auto . This automatically
sets the system IRQ for the PCI slot.

Onboard SCSI

This parameter lets you select which interrupt pin to assign for the
onboard SCSI. The selections are interrupt pins A, B, C, D and Auto.
The default setting is Auto . This automatically sets the system IRQ
for the SCSI function.

Available IRQs

These parameters appear and are configurable only if the PnP BIOS
Auto-configuration parameter is disabled. These let you assign a
system IRQ to each PCI slot and for the onboard SCSI. The available
settings are 3, 4, 5, 7, 9, 10, 11, 12, 14, 15 and NA. The NA setting
means no IRQ is assigned to the slot.
Setting the Slot 1/2/3 Using INT# and the Onboard SCSI parameters
to Auto automatically sets the IRQ for each slot function. You may
also change the default to another setting. If you do, make sure that
the IRQs do not conflict.
3-18 User's Guide