Oat Interface; Gps Navigator Interface - uAvionix AV-30-S Installation Manual

10.6.2 OAT Interface

10.6.3 GPS Navigator Interface

UAV-1003947-001, AV-30-C, Installation Manual
If an OAT probe is connected, utilize the display customization
guidance provided in the Pilots Guide to configure the display to
show OAT in at least one textual display field.
Note that OAT calibration is performed in the Setup procedures.
This step only ensures that the OAT probe is detected properly.
If a GPS Navigator is connected, utilize the display
customization guidance provided in the Pilots Guide to configure
the display to show GPS navigational data in at least one textual
display field.
The image below shows a typical configuration that the pilot may
setup.
On the GPS navigator, set a destination waypoint and initiate a
direct-to sequence. Note that not all navigators will output serial
data until a waypoint has been selected and navigation initiated.
Figure 18 – OAT Indication
Figure 19 – OAT Indication
35 Revision C