Table of Contents
Advertisement
7
Installation Locations & Operating Modes
7.1
Installation Locations
The following figure shows a typical "six-pack" and one possible
arrangement of instrument locations:
Note that the physical arrangement in many aircraft varies from the
traditional "T" configuration shown above. The AI/DG locations are
examples of installation locations as a non-required instrument.
The replaced instruments may NOT be part of an autopilot or primary
navigational display, such as an integrated autopilot system, autopilot
heading bug source, attitude source, CDI, HSI or flight director display.
UAV-1003947-001, AV-30-C, Installation Manual
Figure 2 – Mechanical Gauge Replacement
The existing mechanically based altimeter and airspeed
indicator must remain in their factory locations for this
installation configuration.
Installation as a pilot configurable AI/DG may not replace a
primary instrument.
Reference CFR 23.1321 Arrangement and Visibility for
additional FAA guidance on instrument installation location.
AI
DG
AI/DG
15
Revision C
Advertisement
Table of Contents
