Operating Mode Configuration - uAvionix AV-30-S Installation Manual

7.2

Operating Mode Configuration

The AV-30-C operating mode is configured during installation and can
be set as follows:
 Unit locked as a dedicated Attitude Indicator (AI Mode)
 Unit locked as a dedicated Direction Indicator (DG Mode)
 Unit can be toggled between AI and DG mode by the pilot
Installations where dedicated functionality is required must have the
associated setting configured in the setup procedures. This setting is
mandatory and non-pilot accessible.
If the functionality is not locked, pressing and holding the rotary knob
will toggle between AI and DG mode. This mode is only applicable for
installation as a non-required instrument.
Replaced instruments may NOT be part of an autopilot system such as
the rate-of-turn source for an autopilot or display of flight director
information from an autopilot.
UAV-1003947-001, AV-30-C, Installation Manual
An AV-30-C that replaces the Attitude Indicator must have the
operating mode locked as an AI.
An AV-30-C that replaces that Directional Gyro must have the
operating mode locked as a DG.
An AV-30-C installed as a non-required indicator may be
configured in any operating mode based on pilot preference.
16 Revision C