uAvionix AV-30-S Installation Manual page 37

UAV-1003947-001, AV-30-C, Installation Manual
2. Monitor a remote (distant) frequency and verify there are no
unintended squelch breaks or other tones that would interfere with
communications.
3. Monitor an unused frequency and verify there are no unintended
squelch breaks or other tones that would interfere with
communications.
Verify VHF NAV operates without interference from the AV-30-
C.
1. Power on the VHF NAV radio.
2. Monitor a local, remote, and unused frequency.
3. Verify there are no misleading navigation indications during the
monitoring of each frequency.
4. Verify audible station ID and that the station is clear of audio
interference that would prevent identification.
Additional Avionics should be tested according to the
manufacturer EMC/EMI test procedures. This testing assumes
the existing equipment is functional and operating correctly at
time of testing. The following summarizes a typical EMC test.
1. Operate the AV-30-C.
2. Operate the existing installed avionics according to manufacturer
instructions. If capable, utilize the device transmit and receive
functions through a range of values.
3. Verify no errors, warnings, or unexpected operation is observed on
the AV-30-C during operation of the installed avionics.
4. Verify no errors, warnings, or unexpected operation is observed on
the installed avionics during operation of the AV-30-C.
VHF NAV RADIOS
ADDITIONAL AVIONICS
37 Revision C