Install Menu Settings - uAvionix AV-30-S Installation Manual

Rotating the knob left and right will access the various parameters that
may be configured. Pressing the knob when the desired field is shown
will allow the associated setting to be adjusted. After adjustment,
pressing the knob again will disable the editing mode but the Install
Menu will remain active.
Pressing DONE will exit the Setup Menu.

10.4 Install Menu Settings

The Install Menu options and settings must be configured during the
installation procedure:
Setting
Unit Function
Function Lock
Pitch Trim
Roll Trim
Slip Trim
OAT Trim
IAS Trim
ALT Trim
IAS Units
VSpeed Limits
Baro Units
Temp Units
GPS Nav Source
Serial 2
Demo Mode
Software Version
Software Checksum
UAV-1003947-001, AV-30-C, Installation Manual
Figure 16 - Setup Done / Exit Option
Description
Unit Functionality
Functionality Locked
Pitch Trim
Roll Trim
Slip Trim
OAT Probe Trim
IAS Trim
Baro Altitude Trim
IAS Display Units
Vso,Vs1,Vfe,Vno,Vne
Baro Setting Units
OAT Units
Serial Input
Aux Serial Input
Demo Mode
Software Version
Software Checksum
Table 7 – Install Menu Options
32
Options or Range
Set to default mode: AI or DG
If locked, pilot may not toggle function
with knob press
Trim as needed: ±20 Degrees
Trim as needed: ±5 Degrees
Trim as needed: ±5 Degrees
Trim as needed: ±200 (Unitless)
Trim as needed: ±50 (KTS or MPH)
Trim as needed: ±500 Feet
Set to match airspeed: KTS, MPH
Set to match limits: 40 to 300 kts
Set to match altimeter: HG, MB
Set as desired: C, F
Se to match GPS type: NONE, AV1
9600, NMEA1 4800, NMEA1 9600,
BEACON X
Set to NONE
Set to DISABLED
For Reference
For Reference
Revision C