Installation Menu - uAvionix AV-30-C Installation Manual

13 Installation Menu

The installation menu is used to configure the AV-30-C after installation and
should only be accessed on the ground and changed by the installer.
To enable access the installation menu, ensure the unit is completely turned off.
Press and hold the main control knob in while power is applied.
Keep the knob pressed until the startup logo has appeared. The installation
menu will now be enabled for access but will not automatically appear on the
screen.
Ensure the unit is in AI or DG mode; select the mode by pressing and holding
the center button until the mode display changes. When in AI or DG mode,
press and release the left MENU button three times until "INSTALL / ROT TO
SEL" appears. The sequence of fields displayed is shown in Figure 13.
UAV-1003947-001, AV-30-C, Installation Manual
Rev E
Figure 12 - Installation Menu Access
34