Installation Locations & Operating Modes; Installation Locations - uAvionix AV-30-C Installation Manual

Hide thumbs Also See for AV-30-C:

Table of Contents

9 Installation Locations & Operating Modes

9.1

The following figure shows a typical "six-pack" and one possible

arrangement of instrument locations:

Note that the physical arrangement in many aircraft varies from the

configuration shown above. The AI/DG locations are examples of installation

locations as a non-required instrument.

The existing mechanically based altimeter and airspeed indicator

must remain in their factory locations for this installation

configuration.

Installation as a pilot configurable AI/DG may not replace a primary

instrument.

The replaced instruments may NOT be part of an autopilot or primary

navigational display, such as an integrated autopilot system, autopilot

heading bug source, attitude source, CDI, HSI or flight director display.

Reference CFR 23.1321 Arrangement and Visibility for additional

FAA guidance on instrument installation location.

UAV-1003947-001, AV-30-C, Installation Manual

Rev E

Figure 2 – Mechanical Gauge Replacement

Table of Contents