Table of Contents
Advertisement
414 Wheels and tyres
The vehicle is not on a slope.
R
The vehicle is on solid, non-slippery and level
R
ground.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Vehicles with automatic transmission:
#
shift into position j.
Vehicles with level control system: set the
#
normal vehicle level (
page 214).
→
Switch off the engine.
#
Make sure that the engine cannot be started.
#
Place chocks or other suitable items under
#
the front and rear of the wheel that is diago‐
nally opposite the wheel you wish to change.
Remove the hub caps if necessary
#
(
page 414).
→
Raise the vehicle (
page 415).
→
#
Removing and fitting hub caps
Requirements:
The vehicle is prepared for a wheel change
R
(
page 413).
→
Plastic hub cap
To remove: turn the centre cover of the hub
#
cap anti-clockwise and remove the hub cap.
To fit: make sure that the centre cover of the
#
hub cap is turned anti-clockwise.
Position the hub cap and turn the centre
#
cover clockwise until the hub cap engages
physically and audibly.
Aluminium hub cap
To remove: position socket
#
1.
%
The socket can be found in the tyre-change
tool kit.
Position wheel spanner
3
#
Using wheel spanner 3, turn hub cap
#
anti-clockwise and remove it.
To fit: position hub cap
1
#
completely flush with the wheel.
Position socket
2
on hub cap 1.
#
2
on hub cap
on socket 2.
1
and turn until it is
Advertisement
Table of Contents
