Table of Contents
Advertisement
Drive forwards or reverse very slowly for
#
approximately 10 m.
Pump up the tyre again.
#
After a maximum of ten minutes the tyre
pressure must be at least 200 kPa (2.0 bar/
29 psi).
& WARNING Risk of accident due to the
specified tyre pressure not being ach‐
ieved
If the specified tyre pressure is not achieved
after the specified time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
Damaged tyres and a tyre pressure that is
too low can significantly impair braking and
handling characteristics.
Do not drive on.
#
Consult a qualified specialist workshop.
#
If, after ten minutes, a tyre pressure of
200 kPa (2.0 bar/29 psi) has been achieved:
Switch off the tyre inflation compressor.
#
Unscrew the filling hose from the valve of the
#
defective tyre.
& WARNING Risk of accident from driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
impairs driving characteristics and is not
suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed
#
limit with a tyre that has been repaired
using tyre sealant.
Observe the maximum permissible speed for
#
a tyre sealed with tyre sealant 80 km/h.
Affix the upper section of the TIREFIT sticker
#
to the instrument cluster in a location where
it will be easily seen by the driver.
* NOTE Staining from leaking tyre sealant
After use, excess tyre sealant may leak out
from the filling hose.
Breakdown assistance 385
Therefore, place the filling hose in the
#
plastic bag that contained the TIREFIT
kit.
+
ENVIRONMENTAL NOTE Environmental
pollution caused by environmentally irre‐
sponsible disposal
Tyre sealant contains pollutants.
Have the tyre sealant bottle disposed of
#
professionally, e.g. at a Mercedes-Benz
Service Centre.
Stow the tyre sealant bottle, the tyre inflation
#
compressor and the warning triangle.
Pull away immediately.
#
Stop driving after approximately ten minutes
#
and check the tyre pressure using the tyre
inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
Advertisement
Table of Contents
