Brakes - Can-Am 219 002 095 Operator's Manual

Inspect ball joints boot for cracks.
Push and pull the wheels from the up-
per and lower edge to feel the play.
See an authorized Can-Am dealer if
there is an abnormal play or the boot is
cracked.
vmo2011-011-117_a
TYPICAL
WARNING
The ball joint must be replaced if
the boot is cracked or it shows an
abnormal play. See an authorized
Can-Am dealer.
Front Suspension Arms
Check suspension arms for cracks,
bending or other damage.
See an authorized Can-Am dealer as
necessary.
Rear Trailing Arms
Check trailing arms for distortion,
cracks or bending.
See an authorized Can-Am dealer if any
problem is detected.

Brakes

Brake Fluid Reservoir Level
Verification
With vehicle on a level surface, check
brake fluid in reservoirs for proper
level.
NOTE: A low level may indicate leaks
or worn brake pads.
Front Brake Reservoir Level
Verification
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of the
top of window.
Visually inspect lever boot condition.
Check for cracks, tears, etc. Replace if
damaged.
vmo2012-014-022_a
TYPICAL
Rear Brake Reservoir Level
Verification
Remove the seat.
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of brake pedal fluid reser-
voir.
______________
MAINTENANCE PROCEDURES
135