Brakes - Can-Am SPYDER F3TM 2016 Operator's Manual

MAINTENANCE PROCEDURES
For best performance, use LONG LIFE
ANTIFREEZE (P/N 219 702 685) or
equivalent.
With the engine cold, check the
coolant level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Open the front storage compart-
ment.
3. Remove front service cover. Refer
BODY
to .
4. Check the coolant level on the right
hand side. Coolant must be visible
slightly above the COLD. level mark.
NOTE: If engine is hot, coolant must
be visible without exceeding the HOT.
level mark.
rmo2015-008-027_a
1. Coolant reservoir cap
5. If required, add coolant until it is vis-
ible in the reservoir slightly above
the COLD level mark. Use a funnel
to avoid spillage.
Do not overfill.
6. Stop adding coolant once coolant
starts to appear in the tube.
______________
102
rmo2014-001-003_a
TYPICAL
1. HOT coolant level reference line
7. Reinstall the service cover.
NOTE: A coolant system that fre-
quently requires coolant indicates
leaks or engine problems. See an au-
thorized Can-Am roadster dealer.

Brakes

WARNING
New brakes will not operate at
their maximum efficiency until
their break-in is completed. Brak-
ing performance may be reduced,
so use extra caution. Brakes take
about 300 km (200 mi) of riding
with frequent braking to break-in.
For riding with infrequent braking,
allow extra time to break-in the
brakes.
Brake Fluid Level Verification
Use only DOT 4 brake fluid from a
sealed container.
Check the brake fluid level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Remove RH lateral service cover.
BODY PANELS
Refer to
3. Remove RH side panel. Refer to
BODY PANELS
4. Check the brake fluid level in reser-
voir. They should both be above the
MIN. mark.
.
.