Cvt Cover - Can-Am 219 002 095 Operator's Manual

Spark Plug Installation
Prior to installation, make sure that
contact surfaces of cylinder heads and
spark plugs are free of grime.
Using a feeler gauge, set the spark plug
gap.
SPARK PLUG GAP
570
650
850
1000R
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads to prevent a possible seizure.
Screw spark plugs into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
CAUTION Do not overtighten
spark plugs, engine damage can oc-
cur.
TIGHTENING TORQUE
Spark plug (570
and 650)
Spark plug (850
and 1000R)

CVT Cover

NOTE: For a better understanding,
some illustrations are taken with en-
gine out of vehicle. To perform the
following instructions, it is not neces-
sary to remove engine.
This CVT is lubrication free. Never lu-
bricate any components except drive
pulley bearing.
WARNING
Never touch CVT while engine is
running. Never drive vehicle when
CVT cover is removed.
0.8 mm to 0.9 mm
(.031 in to .035 in)
0.7 mm to 0.9 mm
(.028 in to .035 in)
20 N•m ± 2.4 N•m
(15 lbf•ft ± 2 lbf•ft)
11 N•m ± 1 N•m
(97 lbf•in ± 9 lbf•in)
______________
MAINTENANCE PROCEDURES
WARNING
Engine must be cool before cover
is removed. Always wear protec-
tive gloves when removing cover.
Place the vehicle on a level surface.
Select PARK position.
CVT Cover Access
The CVT cover is located on the LH side
of the vehicle.
Remove the following:
– LH side and extension panels
– LH footboard panel.
219002021-001
TYPICAL
1. CVT cover
CVT Cover Removal
Remove all CVT cover retaining
screws.
Remove the center top screw last to
support the cover during removal.
NOTICE
Do not use an impact tool
to remove CVT cover screws.
Remove the CVT cover and its gasket.
123