Steering; Suspension; Brakes - Can-Am 570 Series Operator's Manual

fvmo2013-001-011
TYPICAL — BACK UP POINT LOCATION

17) Steering

Steering Inspection
Tie-Rods
Inspect tie-rod boots for cracks.
WARNING
The tie-rod must be replaced if the
boot is cracked.

18) Suspension

Front Suspension Lubrication
Lubricate front A-arms at grease fit-
tings.
SUSPENSION GREASE
BRP
recommended
product
Rear Suspension Lubrication
Lubricate rear stabilizer bar links and
pivot bushing at grease fittings.
SUSPENSION GREASE
BRP
recommended
product
SUSPENSION
GREASE
(P/N 293 550 033)
SUSPENSION
GREASE
(P/N 293 550 033)
______________
II MAINTENANCE PROCEDURES
Suspension Inspection
Shock Absorbers
Inspect shock absorber for oil leaks or
other damage.
Check tightness of fasteners.
See an authorized Can-Am dealer as
necessary.
Ball Joints
Inspect ball joint boots for cracks.
WARNING
The ball joint must be replaced if
the boot is cracked.
Front A-Arms
Check A-arms for cracks, bending or
other damage.
See an authorized Can-Am dealer as
necessary.
Rear Trailing Arms
Check trailing arms for distortion,
cracks or bending.
See an authorized Can-Am dealer if any
problem is detected.

19) Brakes

Brake Fluid Reservoir Level
Verification
With vehicle on a level surface, check
brake fluid in reservoirs for proper
level.
NOTE: A low level may indicate leaks
or worn brake pads.
Front Brake Reservoir Level
Verification
Turn steering in the straight-ahead po-
sition to ensure reservoir is level.
Check the brake fluid level, the reser-
voir is full when the fluid reaches of the
top of window.
Visually inspect lever boot condition.
143