Engine Coolant - Can-Am 219 002 095 Operator's Manual

MAINTENANCE PROCEDURES

Engine Coolant

Engine Coolant Level Verification
WARNING
Check coolant level with engine
cold. Never add coolant in cooling
system when engine is hot.
1. Place vehicle on a level surface.
2. Remove seat.
3. Lift the front part of the central
panel.
vmo2008-005-002_a
TYPICAL
1. Lift here
4. Remove console. Refer to
MENT
.
5. Remove engine coolant reservoir
cap.
6. With vehicle on a level surface, liq-
uid should be between MIN. and
MAX. level marks of coolant reser-
voir.
vmo2012-014-019_a
1. Engine coolant reservoir
______________
114
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it may
be slightly lower than MIN. mark.
7. Add coolant if required.
Do not remove the coolant reser-
voir cap if engine is hot.
8. Use a funnel to avoid spillage. Do
not overfill.
9. Properly reinstall and tighten reser-
voir cap.
In order to avoid potential burns,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Can-Am dealer.
Reinstall:
– Console
– Gauge support
EQUIP-
– Seat.
Recommended Engine Coolant
Scandinavia
All other countries
Alternative, or if
not available
WARNING
WARNING
COUNTRY
RECOMMENDED
COOLANT
EXTENDED LIFE
PRE-MIXED
COOLANT (EUR)
(P/N 779223)
EXTENDED LIFE
PRE-MIXED
COOLANT
(P/N 779150)
Distilled water
and antifreeze
solution (50%
distilled water,
50% antifreeze)