Multifunction Switch - Can-Am 219 002 095 Operator's Manual

CONTROLS
If you have more than one D.E.S.S.
equipped Can-Am vehicle, each can
be programmed by your authorized
Can-Am dealer to accept the other ve-
hicle D.E.S.S. keys.

7) Multifunction Switch

The multifunction switch is located on
the LH side of the handlebar.
The controls located on this multifunc-
tion switch are:
219001733-001_a
TYPICAL — MULTIFUNCTION SWITCH
1. Headlight switch
2. Engine stop switch
3. Engine start button
4. Override/DPS button (if applicable)
Low/High/OFF Headlight Switch
This switch is used to select either the
headlights low or high beams or to turn
lights OFF.
219001733-003_a
HEADLIGHT SWITCH FUNCTIONS
1. Lights OFF
2. Low beam
3. High beam
______________
76
Engine Stop Switch
219001733-001_b
TYPICAL
1. Engine stop switch
This switch can be used to stop the en-
gine and as an emergency control.
To stop engine, set the engine stop
switch to the STOP position.
NOTE: Engine can be stopped by set-
ting the engine stop switch to the
STOP position.
Engine Start Button
219001733-00_g
TYPICAL
1. Engine start button
2. Engine stop switch
When engine start button is pressed
and held, it starts the engine.
NOTE: To allow engine starting, the
D.E.S.S. key must be securely installed
on the D.E.S.S. post and the engine
stop button set to RUN.
To power up the vehicle without start-
ing the engine, refer to
THE ELECTRICAL SYSTEM
WAKING UP
.