Brakes - Can-Am Spyder RT Operator's Manual

Brakes

WARNING
New brakes will not operate at
their maximum efficiency until
their break-in is completed. Brak-
ing performance may be reduced,
so use extra caution. Brakes take
about 300 km (200 mi) of riding
with frequent braking to break-in.
For riding with infrequent braking,
allow extra time to break-in the
brakes.
Brake Fluid Level Verification
Use only DOT 4 brake fluid from a
sealed container. An opened container
may be contaminated or may have ab-
sorbed moisture from the air.
NOTICE
To avoid serious damage
to the braking system, do not use
non-recommended fluids.
fluid can damage plastic and painted
surface. Handle with care.
WARNING
Avoid getting brake fluid on skin
or in eyes – it may cause severe
burns. In case of contact with the
skin, wash thoroughly. In case of
contact with the eyes, immediately
rinse with plenty of water for at
least 10 minutes and then consult
a doctor immediately.
Check the brake fluid level as follows:
WARNING
Clean filler cap before removing.
Use only DOT 4 brake fluid from a
sealed container.
1. Park the vehicle on a firm, level sur-
face.
2. Unlatch and lift the seat
THE SEAT (p.39)
.
3. Check the brake fluid level in both
reservoirs, near the back of the seat.
They should both be above the MIN.
mark.
rmo2010-001-013_b
1. Brake fluid reservoir
4. Clean the filler caps before remov-
ing.
5. Add fluid as required. Do not over-
Brake
fill.
rmo2010-001-091_a
1. Brake fluid MAX. level mark
2. Brake fluid MIN. level mark
OPENING
rmo2010-001-092_a
A. Operating range
______________
MAINTENANCE PROCEDURES
129