Engine Coolant - Can-Am SPYDER F3TM 2016 Operator's Manual

rmr2015-109-002_a
Step 1: Remove all four screws
Step 2: Remove air filter cover
rmr2015-109-003_a
REMOVE AIR FILTER FROM AIR INTAKE
SILENCER.
1. Air filter
NOTICE
Remove air filter slowly
to keep dust and debris from falling
into the clean area of the air intake
silencer (passed air filter).
Air Filter Inspection
Inspect air filter for cleanliness and
damage.
NOTICE
It is not recommended to
blow compressed air on the paper
filter. This could damage the paper
fibers and reduce its filtration ability
when used in dusty environments.
NOTICE
Do not wash the paper fil-
ter with any cleaning solution.
NOTICE
Inspect air intake silencer
and remove any dust or debris tak-
ing care not to blow or move any-
thing inside the clean side of the
engine air inlet (passed air filter).
NOTICE
bris that may have moved or shifted
inside the clean side of the air intake
silencer (passed air filter). Clean by
pulling on the dust and not pushing
it inside.
Replace air filter as necessary accord-
ing to recommended maintenance
schedule and particular use (especially
in dusty environments).
Air Filter Installation
Installation is the reverse of removal
however pay attention to the follow-
ing:
Make sure the ring on which the air
filter sits is flat and well positioned be-
fore seating the air filter.
Make sure the air filter is positioned in
the correct orientation.
NOTE: A special area is present on the
filter for writing down date and mileage
at which new filter was installed.
Position air filter cover onto air intake
silencer.
Air filter cover
retaining screws

Engine Coolant

Engine Coolant Level Verification
When opening the reservoir, the
coolant can be very hot and spray
out if the engine is hot. In order
to avoid getting burned, check the
coolant level when the engine is
cold.
The cooling system must be filled with
distilled water and antifreeze solution
(50% distilled water, 50% antifreeze).
______________
MAINTENANCE PROCEDURES
Remove any dust or de-
TIGHTENING TORQUE
3 N•m ± 0.5 N•m
(27 lbf•in ± 4 lbf•in)
WARNING
101