Table of Contents
Advertisement
NI (Node Identifier) command
AT Command: ATNI
Parameter Range: 20-character ASCII string
Related Commands: ND (Node Discover), DN (Destination Node)
Minimum Firmware Version Required: v1.x80
<Networking {Identification}> The NI command is used to set and read a string for identifying a
particular node.
Rules:
•
Register only accepts printable ASCII data.
•
A string can not start with a space.
•
A carriage return ends command
•
Command will automatically end when maximum bytes for the string have been entered.
This string is returned as part of the ND (Node Discover) command. This identifier is also used with
the DN (Destination Node) command.
NO (Node Discover Options) command
AT Command: ATNO
Parameter Range: "0-1
Related Commands: ND (Node Discover), DN (Destination Node)
Minimum Firmware Version Required: v1.xC5
<Networking {Identification}> The NO command is used to suppress/include a self-response to Node
Discover commands. When NO=1 a module doing a Node Discover will include a response entry for
itself.
NT (Node Discover Time) command
AT Command: ATNT
Parameter Range: 0x01 - 0xFC
[x 100 msec]
Default: 0x19 (2.5 decimal seconds)
Related Commands: ND (Node Discover)
Minimum Firmware Version Required: 1.xA0
<Networking {Identification}> The NT command is used to set the amount of time a base node will
wait for responses from other nodes when using the ND (Node Discover) command. The NT value is
transmitted with the ND command.
XBee / XBee-PRO RF Modules 802.15.4 Product Manual
Command descriptions for the XBee/XBee-PRO RF Module
79
Advertisement
Table of Contents
