Cleaning the
Mass Transducer
and Sample Lines
Thermo Fisher Scientific
5. Direct a burst of canned air into the plastic nozzle to clean the inside of
the nozzle. Use an alcohol swab to clean the inside and outside surfaces
of the plastic nozzle (Figure 5–7).
Figure 5–7. Plastic nozzle
6. Reinstall the grit pot and mass transducer.
The mass transducer and sample lines should be cleaned daily, or after each
use.
Tool/materials needed for this procedure:
Canned air
●
Alcohol swab
●
Small flat-head screwdriver
●
Filter exchange tool.
●
Maintenance and Calibration
Cleaning the Mass Transducer and Sample Lines
PDM 3600 Instruction Manual
5-5