Stopping A Programmed Run - Thermo Scientific 3600 PDM Manual

Stopping a
Programmed Run
Follow these steps to stop a
programmed sample run:
Thermo Fisher Scientific
When the sample run has completed, the WinPDM PDM - COM1 screen
will display a "STOP" message on the screen. The PDM unit will display
the appropriate completed sample screens (Chapter 2) until you download
the data from the PDM unit, or until you start another primary or
programmed sample run.
You can stop a programmed sample run at any time after you have
programmed the sample run using the WinPDM software.
1. Connect the PDM unit to its charger and the PC, and ensure that the
charger and the PDM are both functioning correctly.
2. Start the WinPDM software application. The circular bulb in the
center of the PDM - COM1 screen should be "lit." Also, the PDM -
COM1 screen should display the start date and time, a "Warming"
message, or a "Running" message on the screen.
3. When in the PDM - COM1 screen, select the "Clear Program" button
that is located in the middle of the screen. The PDM - COM1 screen
will display a "STOP" message on the screen
Figure 3–9. Clearing Program
Using the WinPDM Software

Stopping a Programmed Run

(Figure 3–9).
PDM 3600 Instruction Manual 3-9