Starting A Programmed Sample Run - Thermo Scientific 3600 PDM Manual

Using the WinPDM Software

Starting a Programmed Sample Run

Starting a
Programmed
Sample Run
To start a programmed sample run:
3-6 PDM 3600 Instruction Manual
You must use the WinPDM communications software to start and stop a
programmed sample run. When you use the WinPDM communications
software application to set up a programmed sample run, you can not stop
or change the sample run duration by pressing the "A" ("WAKE UP") or
"B" ("SCROLL") button on the PDM's display.
If you want to stop or change a programmed sample run, you must connect
the PDM unit to its charger and to your PC, and use the WinPDM
software to perform any necessary changes to the sample run.
1. Connect the PDM unit to its charger and the PC, and ensure that the
charger and the PDM are both functioning correctly.
2. Start the WinPDM software application.
3. When in the PDM - COM1 screen, select the "Program Shift" button
(located on the left-hand side of the screen under the "Program"
heading) to display the Program shift screen
Figure 3–5. Program Shift screen
4. When in the Program Shift screen, set up the appropriate parameters
for your sample run and then select the "OK" button. All numbered
fields must have an entry. N/A may be entered if the field is not
required. All fields accept alphanumeric entries. If you have correctly
set up the sampling parameters, the PDM - COM1 screen will display
the start date and time on the screen and the dark circular bulb located
in the center of the screen will light up
correctly set up the sampling parameters, a Warning/Confirmation
(Figure 3–5).
(Figure 3–6). If you have not
Thermo Fisher Scientific